Re: Linux, tcpdump and vlan

Ben Greear wrote:

Patrick McHardy wrote:

quoted

Put another way, once you enable VLAN header stripping, you
won't see the headers for *any* VLAN, not only for those you're
actually running locally. This is also a problem for devices
like macvlan, where it would be desirable to make use of
hardware VLAN accerlation. I was thinking about storing the
information somewhere in the packets meta-data on both RX and
TX paths, that would also allow tcpdump to properly display
packets.
  

MAC-VLAN could gather this information based on it's parent
device (ie, if parent-dev has VID 7, then add VID 7 to the meta
data.  There would be no need for any driver changes I think.

Its actually more a problem on the RX path. VLAN acceleration
works (at least with some drivers) by enabling HW header striping
and using the VLAN ID for an immediate lookup in the VLAN devices
configured on that device. So if the VLAN is not configured on the
real device but something like macvlan, it will get the packet
without a header and without any indication that this was a VLAN
packet. This is also what causes the tcpdump problem.

On the TX path, it could simply use the CB, but this is actually
also wrong (for both macvlan and real devices) since qdiscs have
ownership of the skb in between, and at least netem *does* modify
the CB, breaking VLAN.

Other than TCP-dump, or some other raw protocol that wants to see
the VLAN header in user-space, I can't think of what use this would
be, however.  And, if you just disable VLAN accel in the NIC (see below),
that would make this mac-vlan hackery not needed at all?

Optimizations for macvlan are not too important, I agree. But for
tcpdump I consider it a bug.

quoted

I have planned to look into this when I find some time.
Your suggestion of disabling VLAN acceleration in promiscous
mode sounds like a reasonable solution until then ..
  

I think a better method would be to allow disabling VLAN HW accel for a
NIC with
ethtool.  Then, the packets will be received by the software stack with
the vlan
header intact.  Something sniffing on the physical dev will
automatically get the
VLAN header.

That would also be fine. But considering that the TX path is
problematic too, a clean solution for all of this would be
to store the VLAN id in the skb. And we do have some holes
to plug currently :)