On Wed, 2007-06-27 at 20:05 -0400, jamal wrote:

peoplez,

I have added support for tg3 on batching. I see equivalent performance
improvement for pktgen as i did with e1000 when using gige. 
I have only tested on two machines (one being a laptop which does
10/100Mbps). Unfortunately in both cases these are considered to be in
the class of  "buggy" tg3s (which take a longer code path).

To the tg3 folks - can you double check if am off on something?
I have split a few things that you may like as well.
I havent upgraded the tree - it is still circa 2.6.22-rc4 based; at some
point i will sync with Daves net-26

Anyone who has tg3 based hardware: I would appreciate any testing and
results ...

The git tree is at:
git://git.kernel.org/pub/scm/linux/kernel/git/hadi/batch-lin26.git
but i have attached the patch in case you just wanna stare.

cheers,
jamal

Hi Jamal.  I'll be testing your patch soon, but I wanted to point out a
bug in the patch.  The patch defines TG3_SKB_CB() as follows :

#define TG3_SKB_CB(__skb) ((struct tg3_tx_cbdata *)&((__skb)->cb[0]))

This definition will collide with the VLAN macros if TG3_VLAN_TAG_USED
is set.  vlan_tx_tag_get() is defined as :

#define vlan_tx_tag_get(__skb)  (VLAN_TX_SKB_CB(__skb)->vlan_tag)

VLAN_TX_SKB_CB is defined as :

#define VLAN_TX_SKB_CB(__skb) \
        ((struct vlan_skb_tx_cookie *)&((__skb)->cb[0]))

Also, I think the count, max_per_txd, and nr_frags fields of the
tg3_tx_cbdata struct are not needed.