Re: [airo.c bug] Couldn't allocate RX FID / Max tries exceeded when issueing command

On Wed, 2006-11-01 at 22:14 -0500, Ivan Matveich wrote:

hardware: ibm thinkpad t30
kernel: 2.6.18
problem:

airo(): Probing for PCI adapters
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
ACPI: PCI Interrupt 0000:02:02.0[A] -> Link [LNKC] -> GSI 11 (level,
low) -> IRQ 11
airo(eth1): Found an MPI350 card
airo(eth1): Max tries exceeded when issueing command
airo(eth1): Couldn't allocate RX FID
airo(eth1): Could not map memory
airo(): Finished probing for PCI adapters

It appears that the driver cannot talk to your card; see the "max tries
exceeded when issueing command".  Did this card work previously with a
kernel?  Can narrow down which kernels have problems and which don't?

Any ideas?

1) Firmware upgrade/downgrade? (How?)

It's a bit hard to figure out what firmware you have because the driver
can't talk to the card; can you boot under Windows and determine that
using the Cisco wireless utility?  You also need to flash the card under
Windows, not Linux, ideally to a version of firmware greater than
5.60.08.

2) Command sequence to better reset the card? Documentation?

reloading the driver (rmmod airo; modprobe airo) should reset the card.

Dan