On Monday 27 November 2006 15:47, Jens Osterkamp wrote:

While experimenting with a copper passthrough module in bladecenter I found 
out that this needs autonegotiation enabled in order to work properly.
This quick hack enables it with the sideeffect of breaking other bladecenter 
switch configurations.
If anyone has any suggestions or has experimented with the same configuration, 
feel free to comment.

There was a patch from Ishizaki Kou recently, to set up autonegotiate
and other things, see http://patchwork.ozlabs.org/linuxppc/patch?id=8121 .

Are you sure that you don't need any of those changes as well?

	Arnd <><