Re: r8169 driver problem with RTL8110SB chip (on iop3xx ARM board)

* Francois Romieu [off-list ref] [2006-08-03 17:05]:

Btw, can you pass the module a 'debug=32767' option when it is loaded to
increase its verbosity.

That doesn't give me much more messages but now I get one error
message that is probably significant:

eth0: PCI error (cmd = 0x0157, status = 0x6238).


Full log:

r8169 Gigabit Ethernet driver 2.2LK-NAPI loaded
mac_version == Unknown
phy_version == RTL_GIGA_PHY_VER_D (0000)
eth0: Identified chip type is 'RTL8169s/8110s'.
eth0: RTL8169 at 0xc885e200, 00:14:fd:10:27:74, IRQ 27
mac_version == Unknown
phy_version == RTL_GIGA_PHY_VER_D (0000)
MAC version != 0 && PHY version == 0 or 1
Do final_reg2.cfg
Set MAC Reg C+CR Offset 0x82h = 0x01h
r8169 Gigabit Ethernet driver 2.2LK-NAPI loaded
mac_version == Unknown
phy_version == RTL_GIGA_PHY_VER_D (0000)
eth1: Identified chip type is 'RTL8169s/8110s'.
eth1: RTL8169 at 0xc8860300, 00:14:fd:10:00:00, IRQ 28
mac_version == Unknown
phy_version == RTL_GIGA_PHY_VER_D (0000)
MAC version != 0 && PHY version == 0 or 1
Do final_reg2.cfg
Set MAC Reg C+CR Offset 0x82h = 0x01h
libata version 1.20 loaded.
...
Freeing init memory: 88K
Adding 506008k swap on /dev/sda5.  Priority:-1 extents:1
across:506008k
EXT3 FS on sda3, internal journal
r8169: eth0: link up
eth0: PCI error (cmd = 0x0157, status = 0x6238).
NETDEV WATCHDOG: eth0: transmit timed out
eth0: PCI error (cmd = 0x0157, status = 0x6238).

-- 
Martin Michlmayr
http://www.cyrius.com/