Re: Intel ixgb driver bug in linux-2.6.17-rc6-mm2

On Tue, Jun 20, 2006 at 02:13:45PM -0700, Jesse Brandeburg wrote:

On 6/20/06, Linas Vepstas [off-list ref] wrote:

quoted

I sat down to do some testing of the ixgb driver a few days ago, and
get failures within seconds.  From what I can tell, I'm getting either a
DMA to a bad address or some other PCI bus error, not sure which.
The problem appears to happen only for the driver that's in
2.6.17-rc6-mm2. As a sanity check, I'm testing the SuSE SLES10 beta,
which is 2.6.16 based, and it doesn't seem to have any problems.

My test is dirt-simple: telnet to the chargen port.  After an eyeblink,
I get the pci bus error, that's that. "eyeblink" is after about 300MBytes
transfered.  That was with a driver with NAPI enabled. I tried again
with NAPI disabled, and got to about 1.8 GB transfered in two eyeblinks.

To make sure that I'm not dealing with faulty hardware, I tried the same
thing w/ SLES10 2.6.16.18-1.8  and have gotten to RX bytes:20889480686
(19921.7 Mb) so far, with no problems. I don't have easy access to a PCI
bus analyzer, otherwise, I'd tell you more. Ideas? Suggestions?

I could try taking the diff between these two driver versions, and
seeing what change caused the problem, but thought I should email first,
before doing that.

try disabling TSO using ethtool and see if that helps any.

Bing!  That appears to have fixed it !

you're running 1.0.109, correct?

Yes.  DRV_VERSION     "1.0.109-k2"

what does cat /proc/interrupts say (are you running MSI?)

No MSI, this is on older hardware.  
163:       3769     450130      14983     439113   XICS      Edge nic5

I'd also like to know if LLTX support (recently added) is causing you
the issue.  What hardware platform? pSeries?  does it EEH? what does
the dump say?

Yes, its pseries; yes, I see this as EEH errors. However, the EEH error
detection is asynchronous, and so the Linux tack trace is throughly
boring: the error is first noticed when the watchdog runs, typically.

--linas

p.s. version 1.0.100-k2 works gret with NAPI on, and the defal TSO.
I haven't yet tried 1.0.109 with NAPI on and TSO off.

--linas