Re: [LARTC] Re: [PATCH 0/2] Runtime configuration of HTB's HYSTERESIS option

On Thu, 2006-06-15 at 11:49 +0200, Martin Devera wrote:

At time of HTB implementation I needed to reach 100MBit speed on 
relatively slow box. The hysteresis was a way. On other side I used 
hand-made TSC based measure tool to compute exact (15%) performance 
gain. Today I'd measure it using oprofile.

When rethinking it again I'd suggest to re-measure real performance 
impact for both flat and deep class hierarchy and consider switching the 
hysteresis off by default (or even to remove the code if the gain is 
negligible). If it is the case then it is the cleanest solution IMHO.

I attended LCA 2006 this year.  There was a presentation by
a group in New Zealand using Debian running on a embedded
box to bring the Internet to rural communities.  Some of
these communities didn't have power or telephone, so the
setup ran over 802.11 over distances of up to 23Km using
solar cells for power.  I don't recall exactly, but I think
the embedded box was using a 486 equivalent.  I think they
had around 40 of these things up and going.

The point of the story is there are people out there who
use Linux on small processors, and often do imaginative 
things with them.  We would be doing them a disservice by 
ripping out the code.

On other side I see no problem with attached patches. Have you tested 
patched kernel with old "tc" tool ?

Yes.