Ethernet driver general problem ....

I encountered today a case, where default RX_RING_SIZE
was too small for the traffic going thru.  (3c59x driver,
and NAT-router application.)

One related problem is, that the RING_SIZE is hard #define
parameter in most driver sources without ability to adjust
it during runtime.  (e.g.  "modprobe zzzz rx_ring_size=512")
Possibly even an  ifconfig:able  parameter, which works
also for statically compiled kernels.  (But needs new
ifconfig machinery...)


The case at hand was solved by editing kernel sources, and
compiling a new kernel, but now I am looking for a more
generic approach.


Clearly pre-allocing 500 buffers of 1.6 kB in size does
eat a bit much of kernel memory which usual workstation
does not get benefit from, but server or router would get
benefits.

Having the rx_ring_size  ifconfig  tunable would help with 
adjusting interface for reception, but adding ifconfig
parameters is ... not trivial.

Alternate might be  sysctl  tunability -- even as a global
'dev.eth.rx_ring_size' (or  'net.dev.eth.rx_ring_size')
which supplies (default) ring size for initialization of
the interface where such rings exist at all...


Possibly there should also be tx_ring_size, which need not
be same size as the rx_ring_size.

Unadjusted default value for both could be 16.


All in all, this needs near uniquitous changes in driver
init codes accross lots of network drivers.


Comments ?  Suggestions ?

  /Matti Aarnio