On IBM POWER systems, newer processor generations can operate in
compatibility modes corresponding to earlier generations. This becomes
relevant for nested virtualization, where nested KVM guests may need to
run with a specific processor compatibility level.

Currently, when running a nested KVM guest (L2) inside a Power11 pSeries
logical partition (L1) booted in Power10 compatibility mode, the guest
fails to boot while setting 'arch_compat'. This happens because the CPU
class is derived from the hardware PVR (via mfspr()), which reflects the
physical processor generation (Power11), rather than the effective
compatibility mode (Power10).

As a result, userspace may request a Power11 arch_compat for the L2
guest. However, the L1 partition, running in Power10 compatibility, has
only negotiated support up to Power10 with the Power Hypervisor (L0).
When H_SET_STATE is invoked with a Power11 Logical PVR, the hypervisor
rejects the request, leading to a late guest boot failure:

  KVM-NESTEDv2: couldn't set guest wide elements
  [..KVM reg dump..]

This situation should be detected earlier. Rejecting unsupported
'arch_compat' values in 'kvmppc_set_arch_compat()' avoids issuing an
invalid H_SET_STATE hcall and provides a clearer failure mode.

Add a check to reject Power11 'arch_compat' requests when the host is
running in Power10 compatibility mode, returning -EINVAL early instead
of deferring the failure to the hypervisor.

Suggested-by: Vaibhav Jain <redacted>
Tested-by: Anushree Mathur <redacted>
Signed-off-by: Amit Machhiwal <redacted>
---
 arch/powerpc/kvm/book3s_hv.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/powerpc/kvm/book3s_hv.c b/arch/powerpc/kvm/book3s_hv.c
index 61dbeea317f3..249d1f2e4e2c 100644
--- a/arch/powerpc/kvm/book3s_hv.c
+++ b/arch/powerpc/kvm/book3s_hv.c

@@ -446,7 +446,19 @@ static int kvmppc_set_arch_compat(struct kvm_vcpu *vcpu, u32 arch_compat)
 			guest_pcr_bit = PCR_ARCH_300;
 			break;
 		case PVR_ARCH_31:
+			guest_pcr_bit = PCR_ARCH_31;
+			break;
 		case PVR_ARCH_31_P11:
+			/*
+			 * Need to check this for ISA 3.1, as Power10 and
+			 * Power11 share the same PCR. For any subsequent ISA
+			 * versions, this will be taken care of by the guest vs
+			 * host PCR comparison below.
+			 */
+			if ((PVR_ARCH_31 & cur_cpu_spec->pvr_mask) ==
+				cur_cpu_spec->pvr_value) {
+				return -EINVAL;
+			}
 			guest_pcr_bit = PCR_ARCH_31;
 			break;
 		default:

-- 
2.50.1 (Apple Git-155)