@@ -12,17 +12,17 @@ potentially including additional information.
 MSIs are distinguished by some combination of:
 
 - The doorbell (the MMIO address written to).
-  
+
   Devices may be configured by software to write to arbitrary doorbells which
   they can address. An MSI controller may feature a number of doorbells.
 
 - The payload (the value written to the doorbell).
-  
+
   Devices may be configured to write an arbitrary payload chosen by software.
   MSI controllers may have restrictions on permitted payloads.
 
 - Sideband information accompanying the write.
-  
+
   Typically this is neither configurable nor probeable, and depends on the path
   taken through the memory system (i.e. it is a property of the combination of
   MSI controller and device rather than a property of either in isolation).

@@ -48,7 +48,7 @@ Optional properties:
   not encode doorbells or payloads as these can be configured dynamically.
 
   The meaning of the msi-specifier is defined by the device tree binding of
-  the specific MSI controller. 
+  the specific MSI controller.
 
 
 MSI clients

@@ -117,7 +117,7 @@ Example
 		reg = <0x1 0xf00>;
 		compatible = "vendor-c,some-device";
 
-		/* 
+		/*
 		 * Can generate MSIs to either A or B.
 		 */
 		msi-parent = <&msi_a>, <&msi_b 0x17>;

@@ -12,7 +12,7 @@ Required properties:
 - compatible : should be: "nvidia,tegra<chip>-ictlr". The LIC on
   subsequent SoCs remained backwards-compatible with Tegra30, so on
   Tegra generations later than Tegra30 the compatible value should
-  include "nvidia,tegra30-ictlr".	
+  include "nvidia,tegra30-ictlr".
 - reg : Specifies base physical address and size of the registers.
   Each controller must be described separately (Tegra20 has 4 of them,
   whereas Tegra30 and later have 5).

@@ -65,14 +65,14 @@ Following are additional properties:
 					Valid values are 0 to 7.
 					This is applicable if FPS source is
 					selected as FPS0, FPS1 or FPS2.
-			
+
 - maxim,active-fps-power-down-slot:	Sequencing event slot number on which
 					the regulator get disabled when master
 					FPS input event set to LOW.
 					Valid values are 0 to 7.
 					This is applicable if FPS source is
 					selected as FPS0, FPS1 or FPS2.
-			
+
 - maxim,suspend-fps-source:		This is same as property
 					"maxim,active-fps-source" but value
 					get configured when system enters in