Pali Rohár [off-list ref] writes:

On Wednesday 06 July 2022 12:43:08 Pali Rohár wrote:

quoted

By default on PPC32 are PCI bus numbers unique across all PCI domains.
So system could have only 256 PCI buses independently of available
PCI domains.

This is due to filling DT property pci-OF-bus-map which does not reflect
multi-domain setup.

On all powerpc platforms except chrp and powermac there is no DT property
pci-OF-bus-map anymore and therefore it is possible on non-chrp/powermac
platforms to avoid this limitation of maximal number of 256 PCI buses in
system even on multi-domain setup.

But avoiding this limitation would mean that all PCI and PCIe devices would
be present on completely different BDF addresses as every PCI domain starts
numbering PCI bueses from zero (instead of the last bus number of previous
enumerated PCI domain). Such change could break existing software which
expects fixed PCI bus numbers.

So add a new config option CONFIG_PPC_PCI_BUS_NUM_DOMAIN_DEPENDENT which
enables this change. By default it is disabled. It cause that initial value
of hose->first_busno is zero.

Signed-off-by: Pali Rohár <pali@kernel.org>
---
 arch/powerpc/Kconfig         | 11 +++++++++++
 arch/powerpc/kernel/pci_32.c |  6 ++++++
 2 files changed, 17 insertions(+)

diff --git a/arch/powerpc/Kconfig b/arch/powerpc/Kconfig
index be68c1f02b79..f66084bc1dfe 100644
--- a/arch/powerpc/Kconfig
+++ b/arch/powerpc/Kconfig

@@ -370,6 +370,17 @@ config PPC_DCR
 	depends on PPC_DCR_NATIVE || PPC_DCR_MMIO
 	default y

+config PPC_PCI_BUS_NUM_DOMAIN_DEPENDENT
+	depends on PPC32
+	depends on !PPC_PMAC && !PPC_CHRP
+	bool "Assign PCI bus numbers from zero individually for each PCI domain"
+	help
+	  By default on PPC32 were PCI bus numbers unique across all PCI domains.
+	  So system could have only 256 PCI buses independently of available
+	  PCI domains. When this option is enabled then PCI bus numbers are
+	  PCI domain dependent and each PCI controller on own domain can have
+	  256 PCI buses, like it is on other Linux architectures.
+

What do you think, would it be possible to set default value of this
option to enabled?

My preference would be to not have the option at all, just make it the
default behaviour. Every new CONFIG option adds more combinations that
need testing, or more likely don't get well tested.

But I don't have a good feel for what could break if we turn it on, so
honestly I don't really know.

Also I do most of my 32-bit testing on pmacs, which are not affected by
the change.

So I'll probably take the series as-is, and then we can do some more
widespread testing and possibly flip the default to enabled, and then
maybe remove the option entirely in future.

cheers