We have wrong units on BAT's sizes (G instead of M, M instead of ...)
---[ Instruction Block Address Translation ]---
0: 0xc0000000-0xc03fffff 0x00000000 4G Kernel x m
1: 0xc0400000-0xc05fffff 0x00400000 2G Kernel x m
2: 0xc0600000-0xc06fffff 0x00600000 1G Kernel x m
3: 0xc0700000-0xc077ffff 0x00700000 512M Kernel x m
4: 0xc0780000-0xc079ffff 0x00780000 128M Kernel x m
5: 0xc07a0000-0xc07bffff 0x007a0000 128M Kernel x m
6: -
7: -
This is because pt_dump_size() expects a size in Kbytes but
bat_show_603() gives the size in bytes.
To avoid risk of confusion, change pt_dump_size() to take bytes.
Signed-off-by: Christophe Leroy <redacted>
---
arch/powerpc/mm/ptdump/ptdump.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/powerpc/mm/ptdump/ptdump.c b/arch/powerpc/mm/ptdump/ptdump.c
index bf251191e78d..031956d0ee84 100644
--- a/arch/powerpc/mm/ptdump/ptdump.c
+++ b/arch/powerpc/mm/ptdump/ptdump.c
@@ -123,7 +123,7 @@ static struct ptdump_range ptdump_range[] __ro_after_init = {
void pt_dump_size(struct seq_file *m, unsigned long size)
{
- static const char units[] = "KMGTPE";
+ static const char units[] = " KMGTPE";
const char *unit = units;
/* Work out what appropriate unit to use */@@ -176,7 +176,7 @@ static void dump_addr(struct pg_state *st, unsigned long addr)
pt_dump_seq_printf(st->seq, REG "-" REG " ", st->start_address, addr - 1);
pt_dump_seq_printf(st->seq, " " REG " ", st->start_pa);
- pt_dump_size(st->seq, (addr - st->start_address) >> 10);
+ pt_dump_size(st->seq, addr - st->start_address);
}
static void note_prot_wx(struct pg_state *st, unsigned long addr)
--
2.33.1