[PATCH v2 12/23] soc: fsl: qe: drop assign-only high_active in qe_ic_init
flat view
STALE2538d
SUPERSEDED
From: Rasmus Villemoes <linux@rasmusvillemoes.dk>
Date: 2019-10-25 12:42:36
Also in:
linux-arm-kernel, lkml
Subsystem:
freescale quicc engine library, freescale soc drivers, the rest · Maintainers:
Qiang Zhao, Christophe Leroy, Linus Torvalds
Status: Superseded by v3 (posted 2019-11-01). [go to v3]
Revision v2 (2 revisions archived).
Revisions (2)
- v2 current
- v3 [diff against previous]
high_active is only assigned to but never used. Remove it. Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk> --- drivers/soc/fsl/qe/qe_ic.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-)
diff --git a/drivers/soc/fsl/qe/qe_ic.c b/drivers/soc/fsl/qe/qe_ic.c
index f3659c312e13..61a40e40f3ae 100644
--- a/drivers/soc/fsl/qe/qe_ic.c
+++ b/drivers/soc/fsl/qe/qe_ic.c@@ -450,7 +450,7 @@ void __init qe_ic_init(struct device_node *node, unsigned int flags, { struct qe_ic *qe_ic; struct resource res; - u32 temp = 0, ret, high_active = 0; + u32 temp = 0, ret; ret = of_address_to_resource(node, 0, &res); if (ret)
@@ -496,10 +496,8 @@ void __init qe_ic_init(struct device_node *node, unsigned int flags, temp |= CICR_GRTB; /* choose destination signal for highest priority interrupt */ - if (flags & QE_IC_HIGH_SIGNAL) { + if (flags & QE_IC_HIGH_SIGNAL) temp |= (SIGNAL_HIGH << CICR_HPIT_SHIFT); - high_active = 1; - } qe_ic_write(qe_ic->regs, QEIC_CICR, temp);
--
2.23.0