Re: [PATCH v3 2/3] powerpc: Discard dynsym section for !PPC32

Joel Stanley [off-list ref] writes:

Alan Modra [off-list ref] explains:

 > Likely you could discard .interp > and .dynstr too, and .dynsym when
 > !CONFIG_PPC32.

Discarding of interp and dynstr happened in a previous patch. The dynsym
cleanup was a bit less straightforward, so it gets it's own patch.

Signed-off-by: Joel Stanley <joel@jms.id.au>

And with the same toolchain this gives me:

  /opt/cross/kisskb/korg/gcc-8.1.0-nolibc/powerpc64-linux/bin/powerpc64-linux-objdump: vmlinux: not a dynamic object
  /opt/cross/kisskb/korg/gcc-8.1.0-nolibc/powerpc64-linux/bin/powerpc64-linux-objdump: vmlinux: Invalid operation
  /opt/cross/kisskb/korg/gcc-8.1.0-nolibc/powerpc64-linux/bin/powerpc64-linux-objdump: vmlinux: not a dynamic object
  /opt/cross/kisskb/korg/gcc-8.1.0-nolibc/powerpc64-linux/bin/powerpc64-linux-objdump: vmlinux: Invalid operation
  /opt/cross/kisskb/korg/gcc-8.1.0-nolibc/powerpc64-linux/bin/powerpc64-linux-objdump: --stop-address: bad number: 0x


cheers