Re: [RFC 0/4] Virtio uses DMA API for all devices

On Tue, 2018-08-07 at 06:55 -0700, Christoph Hellwig wrote:

On Tue, Aug 07, 2018 at 04:42:44PM +1000, Benjamin Herrenschmidt wrote:

quoted

Note that I can make it so that the same DMA ops (basically standard
swiotlb ops without arch hacks) work for both "direct virtio" and
"normal PCI" devices.

The trick is simply in the arch to setup the iommu to map the swiotlb
bounce buffer pool 1:1 in the iommu, so the iommu essentially can be
ignored without affecting the physical addresses.

If I do that, *all* I need is a way, from the guest itself (again, the
other side dosn't know anything about it), to force virtio to use the
DMA ops as if there was an iommu, that is, use whatever dma ops were
setup by the platform for the pci device.

In that case just setting VIRTIO_F_IOMMU_PLATFORM in the flags should
do the work (even if that isn't strictly what the current definition
of the flag actually means).  On the qemu side you'll need to make
sure you have a way to set VIRTIO_F_IOMMU_PLATFORM without emulating
an iommu, but with code to take dma offsets into account if your
plaform has any (various power plaforms seem to have them, not sure
if it affects your config).

Something like that yes. I prefer a slightly different way, see below,
any but in both cases, it should alleviate your concerns since it means
there would be no particular mucking around with DMA ops at all, virtio
would just use whatever "normal" ops we establish for all PCI devices
on that platform, which will be standard ones.

(swiotlb ones today and the new "integrates" ones you're cooking
tomorrow).

As for the flag itself, while we could set it from qemu when we get
notified that the guest is going secure, both Michael and I think it's
rather gross, it requires qemu to go iterate all virtio devices and
"poke" something into them.

It also means qemu will need some other internal nasty flag that says
"set that bit but don't do iommu".

It's nicer if we have a way in the guest virtio driver to do something
along the lines of

	if ((flags & VIRTIO_F_IOMMU_PLATFORM) || arch_virtio_wants_dma_ops())

Which would have the same effect and means the issue is entirely
contained in the guest.

Cheers,
Ben.