Re: Network TX Stall on 440EP Processor

Hi Michael -

Thomas Besemer [off-list ref] writes:

quoted

I'm working on a project that is derived from the Yosemite
PPC 440EP board.  It's a legacy project that was running the
2.6.24 Kernel, and network traffic was stalling due to transmission
halting without an understandable error (in this error condition, the
various
status registers of network interface showed no issues), other
than TX stalling due to Buffer Descriptor Ring becoming full.

I'm not really familiar with these boards, and I'm not a network guy
either, so hopefully someone else will have some ideas :)

This is the EMAC driver you're using, which is old but still used so
shouldn't have completely bit rotted.

I think the "Buffer Descriptor Ring becoming full" indicates the
hardware has stopped sending packets that the kernel has put in the
ring?

So did the driver get the ring handling wrong somehow and the device
thinks the ring is empty but we think it's full?

Thanks for the feedback.  I'm continuing to look into it, but I should add
to this discussion that when TX stalls, the Ready bit (bit 0) is set in the
TX Status/Control field of all the Buffer Descriptors.  This is what is
perplexing, as TX is enabled, and all BD's are marked as having
valid data.

I've looked to see if there are PLB errors, but cannot see any, and the
MAL/EMAC registers all seem valid.  It simply appears that it stops
sending data for no reason.