[PATCH 09/41] powerpc: Update obsolete comments in setup_32.c about entry conditions
From: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Date: 2016-07-05 05:04:56
Subsystem:
linux for powerpc (32-bit and 64-bit), the rest · Maintainers:
Madhavan Srinivasan, Michael Ellerman, Linus Torvalds
early_init() is called in-place before kernel relocation and using whatever MMU setup exists at the point the kernel is entered. machine_init() is called after relocation and after some initial mapping of PAGE_OFFSET has been established (typically using BATs on 6xx/7xx/7xxx processors or some form of bolted TLB on others). Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org> --- arch/powerpc/kernel/setup_32.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/arch/powerpc/kernel/setup_32.c b/arch/powerpc/kernel/setup_32.c
index 34e61d68..3f0aca2 100644
--- a/arch/powerpc/kernel/setup_32.c
+++ b/arch/powerpc/kernel/setup_32.c@@ -61,9 +61,7 @@ int icache_bsize; int ucache_bsize; /* - * We're called here very early in the boot. We determine the machine - * type and call the appropriate low-level setup functions. - * -- Cort <cort@fsmlabs.com> + * We're called here very early in the boot. * * Note that the kernel may be running at an address which is different * from the address that it was linked at, so we must use RELOC/PTRRELOC
@@ -91,6 +89,10 @@ notrace unsigned long __init early_init(unsigned long dt_ptr) /* + * This is run before start_kernel(), the kernel has been relocated + * and we are running with enough of the MMU enabled to have our + * proper kernel virtual addresses + * * Find out what kind of machine we're on and save any data we need * from the early boot process (devtree is copied on pmac by prom_init()). * This is called very early on the boot process, after a minimal
--
2.7.4