---------- Forwarded message ----------
From: Scott Wood <oss@buserror.net>
Date: 2016-06-04 1:23 GMT+01:00
Subject: Re: running qemu for powerpc (32bits) architecture
To: Marwa Hamza <redacted>, <redacted>
On Mon, 2016-05-30 at 10:04 +0100, Marwa Hamza wrote:
hello everyone
I'm trying to run qemu for powerpc architecture but either
1/ i got a black screen with this sentence " QEMU 2.4.0.1 monitor - type
help for more information"
(QEMU)
if i run this command ./ppc-softmmu/qemu-system-ppc -M ppce500 -kernel
../linux-4.4.1/arch/powerpc/boot/zImage -initrd powerpc/busybox
-1.21.0/rootfs.img.gz -append "root=/dev/ram rdinit=/bin/sh"
I can't help with the other platforms, but for ppce500, make sure you have
CONFIG_PPC_QEMU_E500 enabled in the kernel (and that it's an e500 build, of
course), pass either uImage or vmlinux (not zImage) to -kernel, and specify
the desired cpu type on the QEMU command line (using -cpu) to match the type
of kernel you built. I recommend using e500mc rather than older e500
because
then you get standard floating point which your RFS may depend on.
Also note that this target will have a serial port for output, not a
display,
so configure QEMU appropriately with -serial for how you want to access
that.
If you need more help (especially with other PPC platforms) I suggest the
qemu-ppc@nongnu.org mailing list.
-Scott
hey
i tried what you said,
./ppc-softmmu/qemu-system-ppc -M ppce500 -kernel
/home/powerpc/linux-4.4.1/vmlinux -initrd
/home/busybox-1.21.0/rootfs.img.gz -append "root=/dev/ram console=ttyAMA0
rdinit=/sbin/init" -serial stdio -cpu e500mc
an error displayed Qemu can't load kernel vmlinux
other thing i didn't understand how i made sure that CONFIG_PPC_QEMU_E500
enabled in the kernel, what is the default configuration should i use?
what's the e500 build ?
regards
marwa