Re: offlining cpus breakage

On 01/17/2015 07:09 PM, Preeti U Murthy wrote:

On 01/16/2015 08:34 AM, Michael Ellerman wrote:

quoted

On Fri, 2015-01-16 at 13:28 +1300, Alexey Kardashevskiy wrote:

quoted

On 01/16/2015 02:22 AM, Preeti U Murthy wrote:

quoted

Hi Alexey,

Can you let me know if the following patch fixes the issue for you ?
It did for us on one of our machines that we were investigating on.

This fixes the issue for me as well, thanks!

Tested-by: Alexey Kardashevskiy <redacted>	

OK, that's great.

But, I really don't think we can ask upstream to merge this patch to generic
code when we don't have a good explanation for why it's necessary. At least I'm
not going to ask anyone to do that :)

So Pretti can you either write a 100% convincing explanation of why this patch
is correct in the general case, or (preferably) do some more investigating to
work out what Alexey's bug actually is.

On further investigation, I found that the issue lies in the latency of
cpu hotplug operation, specifically the time taken for the offline cpu
to enter powersave mode.

The time between the beginning of the cpu hotplug operation and the
beginning of __cpu_die() operation (which is one of the last stages of
cpu hotplug) takes around a maximum of 40ms. Although this is not
causing softlockups, it is quite a large duration.

The more serious issue is the time taken for __cpu_die() operation to
complete. The __cpu_die() operation waits for the offline cpu to set its
state to CPU_DEAD before entering powersave state. This time varies from
4s to a maximum of 200s! It is not this bad always but it does happen
quite a few times. It is during these times that we observe softlockups.
I added trace prints throughout the cpu hotplug code to measure these
numbers. This delay is causing the softlockup and here is why.

If the cpu going offline is the one broadcasting wakeups to cpus in
fastsleep, it queues the broadcast timer on another cpu during the
CPU_DEAD phase. The CPU_DEAD notifiers are run only after the
__cpu_die() operation completes, which is taking a long time as
mentioned above. So between the time irqs are migrated off the about to
go offline cpu and CPU_DEAD stage, no cpu can be woken up. The above
numbers show that this can be a horridly long time. Hence the next time
that they get woken up the unnatural idle time is detected and
softlockup triggers.

The patch on this thread that I proposed covered up the problem by
allowing the remaining cpus to freshly reevaluate their wakeups after
the stop machine phase without having to depend on the previous
broadcast state.So it did not matter what the previously appointed
broadcast cpu was upto.However there are still corner cases which cannot
get solved with this patch. And understandably because it is not
addressing the core issue, which is how to get around the latency issue
of cpu hotplug.

There can be ways in which the broadcast timer be migrated in time
during hotplug to get around the softlockups, but the latency of the cpu
hotplug operation looks like a serious issue. Has anybody observed or
explicitly instrumented cpu hotplug operation before and happened to
notice the large time duration required for its completion?

Ccing Paul.

Ok, finally the problem is clear. The latency observed during hotplug
was a result of a bug in the tick-broadcast framework in the cpu offline
path as was previously presumed. The problem description and the apt fix
is below.

Alexey, would you mind giving this patch a try yet again ? I will
post it out to mainline as soon as you confirm it fixes your issue.
This patch is a tad bit different from the previous one.

Thanks!

Regards
Preeti U Murthy

-------------------------start patch-----------------------------------

tick/broadcast: Make movement of broadcast hrtimer robust against hotplug

From: Preeti U Murthy <redacted>

Today if a cpu handling broadcasting of wakeups goes offline, it hands over
the job of broadcasting to another cpu in the CPU_DEAD phase. The CPU_DEAD
notifiers are run only after the offline cpu sets its state as CPU_DEAD.
Meanwhile, the kthread doing the offline is scheduled out while waiting for
this transition by queuing a timer. This is fatal because if the cpu on which
this kthread was running has no other work queued on it, it can re-enter deep
idle state, since it sees that a broadcast cpu still exists. However the broadcast
wakeup will never come since the cpu which was handling it is offline, and this cpu
never wakes up to see this because its in deep idle state.

Fix this by setting the broadcast timer to a max value so as to force the cpus
entering deep idle states henceforth to freshly nominate the broadcast cpu. More
importantly this has to be done in the CPU_DYING phase so that it is visible to
all cpus right after exiting stop_machine, which is when they can re-enter idle.
This ensures that handover of the broadcast duty falls in place on offline, without
having to do it explicitly.

Signed-off-by: Preeti U Murthy <redacted>
---
 kernel/time/clockevents.c    |    2 +-
 kernel/time/tick-broadcast.c |    4 ++--
 2 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/kernel/time/clockevents.c b/kernel/time/clockevents.c
index 5544990..f3907c9 100644
--- a/kernel/time/clockevents.c
+++ b/kernel/time/clockevents.c

@@ -568,6 +568,7 @@ int clockevents_notify(unsigned long reason, void *arg)
 
 	case CLOCK_EVT_NOTIFY_CPU_DYING:
 		tick_handover_do_timer(arg);
+		tick_shutdown_broadcast_oneshot(arg);
 		break;
 
 	case CLOCK_EVT_NOTIFY_SUSPEND:

@@ -580,7 +581,6 @@ int clockevents_notify(unsigned long reason, void *arg)
 		break;
 
 	case CLOCK_EVT_NOTIFY_CPU_DEAD:
-		tick_shutdown_broadcast_oneshot(arg);
 		tick_shutdown_broadcast(arg);
 		tick_shutdown(arg);
 		/*

diff --git a/kernel/time/tick-broadcast.c b/kernel/time/tick-broadcast.c
index 066f0ec..e9c1d9b 100644
--- a/kernel/time/tick-broadcast.c
+++ b/kernel/time/tick-broadcast.c

@@ -675,8 +675,8 @@ static void broadcast_move_bc(int deadcpu)
 
 	if (!bc || !broadcast_needs_cpu(bc, deadcpu))
 		return;
-	/* This moves the broadcast assignment to this cpu */
-	clockevents_program_event(bc, bc->next_event, 1);
+	/* This allows fresh nomination of broadcast cpu */
+	bc->next_event.tv64 = KTIME_MAX;
 }
 
 /*

Thanks

Regards
Preeti U Murthy

quoted

cheers


_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev

_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev