Re: Question about EHCI on P4080
From: Scott Wood <hidden>
Date: 2014-02-21 21:08:20
On Thu, 2014-02-20 at 12:56 -0600, Ruchika wrote:
linuxppc, Is there another mailing list which is more appropriate ? If so I'd be happy to get a recommendation.
If you're asking about U-Boot support, the list is u-boot@lists.denx.de Be sure to mention what version of U-Boot you're using, and that you're using a recent U-Boot. Also, don't top post or post the same thing twice. If you're using U-Boot from the Freescale SDK rather than from upstream, then instead get support from support@freescale.com or https://community.freescale.com/ It might be a good idea to go that route regardless, given that this sounds like it may be a hardware compatibility issue. I don't think there is a separate host controller or driver for USB 1.1 (or lower speed USB 2.0) devices on p4080 (though this is common on PCs). -Scott
Thank you Regards ruchika On 2/19/2014 11:55 PM, Ruchika wrote:quoted
Hi, I've been trying to understand why the uboot code is unable to work with USB1.1 devices. On a USB analyzer: I notice on an analyzer that there are no SOF or IN tokens seen on the bus at all. The only after the very first setup packet is sent and ACK'd. The board has a hub chip on it connected to the USB controller via a Ulpi interface. Uboot debug indicates that the transfer times out and was still "Active" The kernel code indicates that a companion driver handles 1.1 devices. Does this mean there are 2 HCD's, one for HS and one for FS/LS in the kernel ? Thank you ruchika_______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev