Re: [PATCH V2 0/6] perf: New conditional branch filter

On 08/30/2013 05:18 PM, Stephane Eranian wrote:

2013/8/30 Anshuman Khandual [off-list ref]

quoted

quoted

        This patchset is the re-spin of the original branch stack sampling
patchset which introduced new PERF_SAMPLE_BRANCH_COND filter. This patchset
also enables SW based branch filtering support for PPC64 platforms which have
branch stack sampling support. With this new enablement, the branch filter support
for PPC64 platforms have been extended to include all these combinations discussed
below with a sample test application program.

I am trying to understand which HW has support for capturing the
branches: PPC7 or PPC8.
Then it seems you're saying that only PPC8 has the filtering support.
On PPC7 you use the
SW filter. Did I get this right?

I will look at the patch set.

Hey Stephane,

POWER7 does not have BHRB support required to capture the branches. Right
now its only POWER8 (which has BHRB) can capture branches in HW. It has some
PMU level branch filters and rest we have implemented in SW. But these SW
filters cannot be applied in POWER7 as it does not support branch stack 
sampling because of lack of BHRB. I have mentioned PPC64 support in the
sense that this SW filtering code could be used in existing or future generation
powerpc processors which would have PMU support for branch stack sampling. My
apologies if the description for the patchset was ambiguous.

Regards
Anshuman