Re: Cannot wake-up from standby with MPC8313

On 01/06/2012 07:53 AM, Norbert van Bolhuis wrote:

On 01/05/12 19:22, Scott Wood wrote:

quoted

On 01/05/2012 09:58 AM, Norbert van Bolhuis wrote:

quoted

thanks for your response.

not setting MSR_POW gives same result.

OK, so you're not getting an interrupt regardless of low-power state.

Check whether the interrupt is getting masked during standby preparation.

Does the interrupt handler run when you're not trying to enter standby?

The GPIO/UART interrupt nor the PMC interrupt are being masked during
standby
preperation.
The GPIO/UART interrupt works fine in "operational" mode.
The PMC interrupt I do not know, is it possible to to get PMC interrupt
without going to standby or deep-sleep ?

The PMC interrupt is mainly of interest when running as a PCI agent, to
be notified when the host changed the desired suspend state in config space.

What changes from operational mode to the test where you omit setting
MSR_POW?

Try dumping SIPNR/SIMSR and GPIER/GPIMR/GPDAT at various points.

-Scott