On Wed, Mar 25, 2009 at 11:08:19AM +0100, Wolfgang Grandegger wrote:

The NAND flash on the TQM8548_BE modules requires a short delay after
running the UPM pattern. The TQM8548_BE requires a further short delay
after writing out a buffer. Normally the R/B pin should be checked, but
it's not connected on the TQM8548_BE. The existing driver uses similar
fixed delay points. To manage these extra delays in a more general way,
I introduced the "wait-flags" property allowing the board-specific driver
to specify various types of extra delay.

Signed-off-by: Wolfgang Grandegger <redacted>

Acked-by: Anton Vorontsov <redacted>

[...]

+	prop = of_get_property(ofdev->node, "fsl,upm-wait-flags", &size);
+	if (prop && size == sizeof(uint32_t))
+		fun->wait_flags = *prop;
+	else
+		fun->wait_flags =
+			FSL_UPM_WAIT_RUN_PATTERN | FSL_UPM_WAIT_WRITE_BYTE;

I'd write it as
		fun->wait_flags = FSL_UPM_WAIT_RUN_PATTERN |
				  FSL_UPM_WAIT_WRITE_BYTE;

-- 
Anton Vorontsov
email: cbouatmailru@gmail.com
irc://irc.freenode.net/bd2