Re: PPC 405 EX USB Development

Hi Stefan,

Also in the SETUP stage where I have set my packet size as 1, as I treat
each of this 3 stages (SETUP, DATA and STATUS) as three different
stages/transactions,  I find that the "Non-Periodic Transmit FIFO/Queue
Status Register" read as soon as I write to the "Non-Periodic Transmit FIFO
Size Register" as "0x10500fa". Before writing the value is "0x80100". Is it
fine that the bit 7 which defines the termination of channel a right thing
to happen? Secondly since i am writing 2 bytes to the FIFO why should the
"Non-periodic TxFIFO Space Avail (NPTxFSpcAvail)" bits of USB0_GNPTXSTS be
0xfa?

The FIFO to which I write:
*USB0_GRXFSIZ - 0x213            USB0_GNPTXFSIZ - 0x1000213*
The above setting mean that my Non-Periodic Transmit register starts at
0x213. So I write my data (8 byte SETUP Token Data) in the following way:
-    Write the first 4 bytes to the starting adress of  0x1000 since I am
using Channel 0  --- (*(volatile unsigned  *)(DHc->base + 0x1000 + (bEnd *
0x1000) + 0x213 + fifo_address_offset))=*((volatile       unsigned
*)pSrcBuf);
-   Then increment the "fifo_adress_offset" by 4 and write the next 4 bytes.


I think that there is some problem in the SETUP (Token) Stage. Can you
please pass any pointers over this?

Regards;
Aadish

On Wed, Feb 25, 2009 at 6:09 PM, Adish Kuvelker [off-list ref]wrote:

Hi Stefan,

I am working on the internal OTG controller. The synopsys DWC.

Regards;
Aadish


On Wed, Feb 25, 2009 at 5:57 PM, Stefan Roese [off-list ref] wrote:

quoted

On Wednesday 25 February 2009, Adish Kuvelker wrote:

quoted

I am developing a Host Controller Driver for the PPC405EX based board. I
have a OTG controller on it, which I have to configure as Host

Controller

quoted

and thus I am witting a HCD for the same. I am stuck at the Control

stage

quoted

wherein although my SETUP stage seems to be going through I get a STALL.

Can anyone help me in this regard as to where would I get a reference

code

quoted

for this?

Are you talking about the 405EX internal USB OTG controller (Synopsys DWC)
or
some other OTG controller?

Best regards,
Stefan