Re: External interrupt on 460EX

Felix,

On Wednesday 15 October 2008, Felix Radensky wrote:

I'm running Linux 2.6.26 on custom board based on AMCC 460EX.
I'm trying to catch interrupt generated by CPLD, but without any luck.

The interrupt is connected to GPIO 45. U-Boot (1.3.4) configures this
pin as external interrupt 12 (interrupt 20 in UIC 3). I've added the
following
entry to board device tree (in opb section)

cpld@2,0 {
    device_type = "cpld";
    interrupts = <20 1>;

Is this interrupt active on rising edge? This is what you have configured 
here. When you need level, active low, then you need to write:

     interrupts = <20 8>;

And be careful which dts version you are using. Is this 20 decimal or hex?

    interrupt-parent = <&UIC3>;
};

In my driver I do the following:

    /* Find CPLD node in device tree */
    np = of_find_node_by_type(NULL, "cpld");
    if (!np) {
        printk(KERN_INFO "No CPLD found in device tree\n");
        return -1;
    }

    /* Get and map irq number from device tree */
    cpld_irq = irq_of_parse_and_map(np, 0);
    if (cpld_irq == NO_IRQ) {
        printk(KERN_ERR "irq_of_parse_and_map failed\n");
        of_node_put(np);
        return -ENODEV;
    }

    /* Register CPLD interrupt handler */
    rc = request_irq(cpld_irq, cpld_interrupt,
             IRQF_TRIGGER_LOW, "CPLD", NULL);

And I see this interrupt in /proc/interrups after loading
the driver. However interrupt handler is never invoked,
although hardware guys see that GPIO line goes down
when interrupt is generated.

What am I doing wrong ?

Another idea is that you didn't configure the pin multiplexing correctly. Most 
external IRQ's are shared with other functions and/or GPIO's. You need to 
configure the multiplexing correctly for external IRQ functionality. This is 
usually done in U-Boot with the CFG_4xx_GPIO_TABLE. 

I suggest you check here first.

Best regards,
Stefan