Re: Problem compiling sequoia using DENX kernel. Xenomai-patch required?

Am Donnerstag, 6. Dezember 2007 schrieb Wolfgang Denk:

In message [ref] you wrote:

quoted

Am Dienstag, 4. Dezember 2007 schrieb Wolfgang Denk:
<...>

quoted

I'm afraid "normal" here still means arch/ppc  -  hopefully  for  not
long any more. Note: a matching Xenomai patch for arch/ppc will be in
Xenomai 2.4 when it comes out in a few days.

Thanks a lot for your explanation. I took 
ksrc/arch/powerpc/patches/adeos-ipipe-2.6.23-ppc-1.6-00.patch 
from the xenomai trunk and was able to compile and boot successfully
the yosemite board (using ARCH=ppc). Will try the sequoaia board tomorrow.

I hope that this is a good starting point to get my custom PPC440EPx board 
into shape. I think once the arch/powerpc will work for PPC440 it should not 
be a lot of work to port it from ppc -> powerpc.

Actually the arch/powerpc tree is working fine here, too.

You might have been unlucky and cloning / pulling  our  tree  at  the
wrong time; we had a stale DENX-v2.6.23.9 tag in there for some time;
unfortunately  the  fix  doesn't  propagate  as  your  side thinks it
already has a valid tag.

Please either "rm .git/refs/tags/DENX-v2.6.23.9" and pull  again,  or
throw  away  the  whole  tree  and  clone again. Sorry for the incon-
venience. And please let me know if this helps (it should).

After following your receipt I recompiled and booted the sequoia board.
Everything seems to work.

Thank you again for your tip. You are always very helpful.
Best regards,

Niklaus Giger