On Nov 29, 2007 2:29 AM, vijay baskar [off-list ref] wrote:

 How to make the linux find the total 2GB memory?


        Hi Friend,

 I hope u had tracked the conversion that has been going on. The max mem
that the kernel can show is only 768 MB because only that of memory is
directly mapped with your ram.. No matter how much ram > 768 MB (in
powerpc.. it varies in other architectures) u have, the kernel will show
only 768 MB.. This is called low mem..

 How t o use high mem??

 scott can probably guide us on this.. I also have lot of confusions about
high mem.. Also i would suggest you a bit of reading on virtual memory
management on linux to get a grasp about how things are done
 Rest for scott

 regards,
 vijai

I also have a requirement to use more than 768MB and 0x30000000. I
have other problems at the moment, so I haven't tested this completely
yet. My limited understanding, though, is that to use more than 768MB
you have to change your kernel configuration, including shifting the
kernel start address. This is what I plan on testing for 1GB when I
have time:

CONFIG_ADVANCED_OPTIONS=y
CONFIG_LOWMEM_SIZE_BOOL=y
CONFIG_LOWMEM_SIZE=0x40000000
CONFIG_KERNEL_START_BOOL=y
CONFIG_KERNEL_START=0xa0000000
# CONFIG_CONSISTENT_START_BOOL is not set
# CONFIG_CONSISTENT_SIZE_BOOL is not set
# CONFIG_BOOT_LOAD_BOOL is not set

If that works for current kernels, please respond to the list ;-) .

HTH,
Robert