Re: PSC in UART mode on TQM5200S

Thanks, i'll try the both ways.
I'm still afraid of killing factory UBoot without
BDI2000 or working X30 jumper :-)

On 9/19/07, Grant Likely [off-list ref] wrote:

On 9/19/07, Leopold Stotch [off-list ref] wrote:

quoted

Thank you for the answer, Grant !
I knew nothing about port_config register before your answer :-(
I haven't changed any processor registers yet
because i'm still searching where i can do this.
Can you tell me, is it UBoot specific or kernel specific or both ?
And i already know about MPC5200's device tree in 2.6.x kernel but not in
2.4.x...

It is best to do it in u-boot; but if you cannot (or don't want to)
change your u-boot image, then you can fix up the port_config value
during early kernel boot.

Cheers,
g.

--
Grant Likely, B.Sc., P.Eng.
Secret Lab Technologies Ltd.
grant.likely@secretlab.ca
(403) 399-0195

-- 
Best regards,
Leopold Stotch