Hello.
ssaravanan@arasor.in wrote:
when i am booting montavista kernel using uboot i couldn't get any message
on Console...
i can view the booting messages by "Dumping the printk Log Buffer". i am
passing the "bootargs=console=ttyS0,115200 root=/dev/ram0 rw"...is that i
I suspect you should use ttyCPM0 instead of ttyS0. Thi board very likely has CPM2, so its UARTs are the only ones that exist.
have to make any modification in kernel configuration to support
appropriate serial port for display boot messags.. find the attached printk
You should enable CONFIG_SERIAL_CPM (if it's not already enabled).
buffer screen shot? can anybody help?
You have actually replied only to me, not the maillist
Regards,
Saravanan.S
WBR, Sergei