Re: Sequoia 440EPx patches not working
From: Vitaly Bordug <hidden>
Date: 2007-08-09 12:56:21
On Wed, 08 Aug 2007 13:45:10 -0500 Jerone Young wrote:
Using the Sequoia (AMCC 440EPx) patches recently submitted to the list I am unable to boot to fully boot a uImage built with these patches under Uboot. It appears to hang in very early boot. Here is the output: => tftp 400000 sequoia/uImage ENET Speed is 100 Mbps - FULL duplex connection (EMAC0) Using ppc_4xx_eth0 device TFTP from server 9.53.41.24; our IP address is 9.53.41.38 Filename 'sequoia/uImage'. Load address: 0x400000 Loading: ################################################################# ################################################################# ################################################################# ####################### done Bytes transferred = 1112434 (10f972 hex) => bootm 400000 ## Booting image at 00400000 ... Image Name: Linux-2.6.23-rc2 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1112370 Bytes = 1.1 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev
This seems to be a wrong image.. Are you using "make zImage" ? The proper uImage after that command would be smth like cuImage* then... -- Sincerely, Vitaly