RE: 8541E and vector table.

Download the MPC8541 reference manual from Freescale web site.
Look in the chapter that says Exceptions (could be chapter 6)
You'll fine the different vectors addresses + explanations about each
vector.

Ami

-----Original Message-----
From: linuxppc-embedded-bounces+ami=3Dwaves.com@ozlabs.org =

[mailto:linuxppc-

embedded-bounces+ami=3Dwaves.com@ozlabs.org] On Behalf Of Steve =

Iribarne

(GMail)
Sent: Tuesday, February 20, 2007 3:21 PM
To: linuxppc-embedded
Subject: 8541E and vector table.
=20
Hi.
=20
I must admit, this stuff always baffles me a bit, so I need someone
who knows this to explain it to me.
=20
I am using an 8541E and my system randomly crashes.  By randomly, I
mean at different times.  I have a BDI hooked up and it always jumps
to offset 0x0000_0700
=20
I believe this to be a vector table offset, but I need to figure out
which interrupt it is.  I believe this is a hardware issued, because
if I look at that value, it looks to be default values.  In other
words, I don't believe I have it setup.
=20
So the question I have is how do I figure out what that interrupt =

vector

is?
=20
Thanks so much.
=20
-stv
=20
--
/*
 * Steve Iribarne
 * Software Engineer
 * (aka Grunt)
 */
_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded