RE: MPC85xx git branch - problem with Marvel SATA driver...

Andy,

CDS is in slot #2, marvel sata card is in Slot #5

I am using the new u-boot git branch from freescale for=20
the MPC85xx_cds. I was told to use this with the new=20
software - which is also using the device tree as well...

Can't tell what version of Arcadia board - where is this located?

All switches on all boards (mother/carrier/cds) are believed
to be in default position as referenced in the cds manual:

    mpc8548_cds_reference.pdf

We haven't done any rocket science here!

Tom


-----Original Message-----
From: Andy Fleming [mailto:afleming@freescale.com]=20
Sent: Friday, February 16, 2007 3:43 PM
To: Morrison, Tom
Cc: linuxppc-dev@ozlabs.org; Geary Sean-R60898; Zhang Wei-r63237
Subject: Re: MPC85xx git branch - problem with Marvel SATA driver...


On Feb 16, 2007, at 14:25, Morrison, Tom wrote:

It smells that there is some type of interrupt / configuration =20
mismatch for the PCI bus for the

CDS that is executed upon this probe sequence of a valid SATA/ATA =20
Port?

Which slot is the CDS carrier card in, and which slot is the SATA =20
card in.  And what interrupt is it trying to register for?

More importantly, what version of u-boot are you running on the =20
board, and what versions of the Carrier Card and Arcadia are you =20
using?  U-Boot rearranges the interrupt-map for PCI based on the slot =20
the CDS Carrier Card is in (which has to be set by a switch on the =20
card).

The code in the tree on opensource.freescale.com only works on the =20
3.1 Arcadia (assuming you also used the DTS that came with it).

Andy