Re: DS1302 driver for powerpc

On Wed, Aug 30, 2006 at 07:54:16PM +0800, Chun Chung Lo wrote:

Hi all,

I am now doing a STB project and the development board uses a DS1302
(trickle charge timekeeping chip) as a RTC. Our board is a IBM PPC405EP
with a linux kernel 2.4.20 running on it. And the DS1302 is controlled
by 2 GPIO pins instead of I2C.

I would like to ask are there any porting of DS1302 support under ppc
architecture? (I can only find DS1302 is supported under cris
architecture.)

There doesn't seem to be any DS1302 support "for ppc" available. However,
even if there were a platform with DS1302 support you'd be in the same
boat as the low-level support for cris.  Support for DS1302 has a glue
layer that's board-specific based on what GPIO pins are used to drive
it.  So if you had this driver for another PPC system like 83xx you'd
still have no better starting point than the cris ds1302 driver glue
since the GPIO mechanism/connection is different. Porting the
board-specific glue from arch/cris/drivers/ds1302.c to 4xx GPIO is
trivial to do though.

-Matt