In message [off-list ref] you wrote:
I lowered the SPI bus frequency, the interrupt is now always happening but I
have always problems.
Try reducing the CPM load. If you have a serial console on a SMC,
shut it off, etc. Then try again (usually it will be better).
have to double check the writing procedure. But it is also worth to note that
changing the PM (prescaler module) and lowering the SPI clock even more the
writing problem is happening less frequently.
Yeah. At a SPI clock of 0 no errors will happen. The problem is, that
this is not too much useful either ;-)
Best regards,
Wolfgang Denk
--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
Contrary to popular belief, thinking does not cause brain damage.