Re: [PATCH 2/2] Add support for MEMEC 2VP30-FF1152 eval board with simple FPGA design

On 9/20/05, Peter Korsgaard [off-list ref] wrote:

quoted

quoted

quoted

quoted

quoted

"Grant" =3D=3D Grant Likely [off-list ref] writes:

=20
Hi,
=20
 Grant> Here is an example port to another V2PRO based board.  This
 Grant> patch is for information only and is NOT suitable for
 Grant> submission up to mainline
=20
Ok, I still have a little comment though..
=20
 Grant> diff --git a/arch/ppc/boot/simple/embed_config.c
 Grant> b/arch/ppc/boot/simple/embed_config.c
 Grant> --- a/arch/ppc/boot/simple/embed_config.c
 Grant> +++ b/arch/ppc/boot/simple/embed_config.c
 Grant> @@ -745,7 +745,7 @@ embed_config(bd_t **bdp)
 Grant>  }
 Grant>  #endif /* WILLOW */
 Grant>
 Grant> -#ifdef CONFIG_XILINX_ML300
 Grant> +#ifdef CONFIG_VIRTEX_II_PRO
 Grant>  void
 Grant>  embed_config(bd_t ** bdp)
 Grant>  {
=20
Please don't force all V2P boards to use the same embed_config. I'm
using RedBoot on a V2P board, which provides a ready to go bd_t that I
can directly use.

No problem.  I need to go back and review this code anyway to
determine if any of it should be split out into common routines for
all v2p boards.

Hey, do you have any drivers for the common 'stock' v2p device cores
ported to 2.6 for your board? (like Ethernet, PS/2, framebuffer, etc)
I'm about to start porting the SystemACE driver and I also need
Ethernet and PS/2 devices, but I don't want to duplicate if anyone has
already done the work.

Thanks again,
g.