Re: USB + MPC5200 L25R REV 2 OCT0511C

Hi Achim and List,

I've recently been doing some experiments regards USB on our custom
icecube-like mpc5200 board using the usb-ohci driver, and here's what I found:

1. Some devices (high speed?) seem to work fine.  I used a USB jump drive.
2. Other devices (low speed?) like USB keyboard and mouse did not.
3. Plugging a USB hub into the board allows the same failing devices
     (kbd & mouse) to work properly (when they are plugged into the hub).
4. The off-the-shelf icecube board behaves the same way, so it's not just our
     board.

I haven't tried to backtrack this because USB isn't a major aspect of 
our product
and I've got higher priorities.

Regards,

Bob Peterson
Advanced Communication Design
(952) 854-4000

At 06:21 AM 8/4/2005, Achim Machura wrote:

Helo list,

do everybody know about problems with usb (usb-ohci) and MPC5200 label  L25R
REV 2 OCT0511C.

When i plugg in a usb-device, i see that the kernel will assign an address
to the device, but it failed by timeout.

The same kernel an the same usb-device works fine on a board with a cpu
label 0L25R QAH0410

best regards

Achim

____________________________________________
Achim Machura Softwareentwicklung
Berghof Automationstechnik GmbH
Harretstrasse 1, D-72800 Eningen u.A.
Tel: +49-7121-894-131, Fax: +49-7121-894-100
email: machura@berghof.com
Internet: http://www.berghof.com


_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded