??: Bad Magic Number when boot linux kernel with ppcboot (PPC860 board)

Dear Denk:
  The magic number is right when using vmlinux.UBoot instead of vmlinux =
or zImage, Why?
  Another question puzzle me:
  The kernel print the "Transferring control to Linux (at address =
00000000) ... "  then halt ,no any response from serial port.
  I tried ramdiak and nfs, there are the same result.
  So why not print the=20
  "Linux version 2.4.25 (root at FedoraCore2) (gcc version 3.3.3 (DENX =
ELDK 3.1
3.3.3-8)) #94 Tue Jul 5 18:59:08 PDT 2005"=20
 =20
  How to not print the "Transferring control to Linux (at address =
00000000) ... "  ? Is it right ?=20
  Thanks a lot!


-----????-----
???: wd@denx.de [mailto:wd@denx.de]
????: 2005?8?2? 15:13
???: FCG WANG Baohua
??: linuxppc-embedded@ozlabs.org
??: Re: Bad Magic Number when boot linux kernel with ppcboot (PPC860 =
board)=20


In message [ref] =
you wrote:

=20
kernel, after I loaded it print the following messages:
=20
=3D> bootm 0x180000
## Booting image at 00000000 ...
Bad Magic Number
=3D>

Which address did you load the image to?

How to slove it, thanks a lot!
I use:  zImage,=20
vmlinux.UBoot,
 vmlinux=20
 it all print the same messages, How can I do?=20

Please read the documentation. Only uImage =3D vmlinux.UBoot can work.

Best regards,

Wolfgang Denk

--=20
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
"Confound these ancestors.... They've stolen our best ideas!"
- Ben Jonson