Re: serial console no response after print "Transferring control to Linux (at address 00000000)" on PPC860

In message [ref] you wrote:

  I use ppcboot and ELDK 3.1.1 kernel 2.4.25 to boot a PPC860 board, I
select the ttyS0, 9600, root=/de/ram during config the kernel.
   I select the SMC1,SMC2 device too. 
  But when bootm 180000, it print the "Transferring control to Linux (at
address 00000000)"  then halt. 
  How can I do? Tell me the detail when config the kernel, thanks!

After all the questions you posted to the mailing list I want to give
two recommendations:

* Please continue to try things for a while (dasy a day or so) before
  posting. This will avoid a lot of unnecessary postings.

* Please do yourself (and us) a favour and  read  the  documentation,
  especially  the  FAQ  section  of the DULG. If you already read it,
  then read it agaion, carefully.
  
Best regards,

Wolfgang Denk

-- 
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@denx.de
You may call me by my name, Wirth, or by my value, Worth.
- Nicklaus Wirth