Re: MPC885 - USB HCI drivers.

On 5/16/05, Wolfgang Denk [off-list ref] wrote:

This code will NOT work on a MPC885.  It  was  written  for  the  old
MPC823/850  processors,  and it NEVER worked really reliably on these
systems either.

=20
Ok, thanks.  Good to know!  Do you know of a driver for the 885, or
for the 8555E?

My advice: use a _real_ USB controller.

Are there known problems with CPM-based USB controllers?  I'm
completely new to the subject, but we are designing a board assuming
we can use the USB controller on an MPC8555E.

Thanks for any comments.  If there are gotchas here, I'd love to find
out about them sooner rather than later.

Cheers,
Kylo