RE: bdi2000 + mpc8560ads, very early breakpoints

Try the suggestions pointed out in here:

http://www.ultsol.com/faq-P308.htm

This is based off suggestions from another customer. Let me know if this
works for you or not.

Fahd

-----Original Message-----
From: Kylo Ginsberg [mailto:kylo@veriwave.com]=20
Sent: Tuesday, April 12, 2005 3:21 PM
To: linuxppc-embedded@ozlabs.org
Subject: bdi2000 + mpc8560ads, very early breakpoints

I'm running a bdi2000 (with mpc85xx-gdb f/w 1.03) with a mpc8560ads=20
target, and I'm trying to set breakpoints early on in linux startup (in=20
the head_e500.S code that sets up tlb's).   I'm setting the breakpoints=20
from within the bdi telnet interface.

I can:
--succesfully hit a breakpoint set up to any instruction <=3D the =
address=20
of the first 'tlbwe'.
--single step (with the bdi "TI" command) past that 'tlbwe' as far as=20
I've cared to try

I cannot:
--hit a breakpoint once the first 'tlbwe' has executed.  If I attempt to

do so, linux startup doesn't proceed, I lose further communication with=20
the target and the BDI claims "COP Freeze" and I have to reset the
target.

Btw, the 'tlbwe' in question marks invalid the first tlb1 entry setup by

u-boot, which pointed at flash address space.  Code is running out of=20
ram at this point.

I'm probably missing something very basic here.  Any ideas?

Thanks,
Kylo

_______________________________________________
Linuxppc-embedded mailing list
Linuxppc-embedded@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-embedded