Re: early UART mapping in head_44x.S

On Tue, Jul 13, 2004 at 05:23:34PM -0400, Ralph Siemsen wrote:

I've been trying to boot a vanilla 2.6.7 kernel on a board similar to
Ocotea (the board boots 2.4.x okay).  I wasn't getting any serial
output, despite setting CONFIG_SERIAL_TEXT_DEBUG and doing early
registration of a console (as per David Woodhouse's posts on this list).

That's a separate issue. I need to go through and early register
the console on 4xx when I get a moment.

After much tracing and a lucky suggestion on IRC, I seem to have
stumbled on the cause, although I don't fully understand what is going
on.  In arch/ppc/kernel/head_44x.S (from 2.6.7 mainline) there is a
block of code that sets up the "early UART mapping".  It does three
tlbwe instructions, and then repeats the same a second time but in
"Translation state 1".  This second set seems to cause my problems.
When I comment out the 5 instructions before the isync, I magically
start getting printk outputs.

Yeah, I fat-fingered the last patch to head_44x.S and left the
duplicate code fragment there. There's a patch submitted to fix
this in mainline.

-Matt

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/