Re: Change FEC and SCC1 sequence,But SCC1 not work?

In message [ref] you wrote:

Briefly, my platform is MPC860T from Motorola. I'm using ppcboot 1.1.16
to tftp the kernel 2.4.4 through FEC and then load NFS/RAMDISK. If I
configure the kernel with only FEC, then everything works well(NFS
works and ping through eth0 works). If I configure the kernel with both
FEC(as eth0) and SCC1(as eth1),it works well too,but when I configure
ther kernel with both SCC1(eth0) and FEC(as eth1) (net/setup.c)! . I
try to ping out through FEC(eth1), I get ring buffer dumps and no ping
response:

Please post the "Kernel command line" as  printed  when  your  kernel
boots.  You  did  include a network device parameter in your ip= boot
argument, didn't you?

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
My challenge to the goto-less programmer  is  to  recode  tcp_input()
without any gotos ... without any loss of efficiency (there has to be
a catch).                                             - W. R. Stevens

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/