Re: unable to input in u-boot at Lite5200

In message [ref] you wrote:

I have burned u-boot.1.0.0 into Lite5200 board (icecube, 16M Flash, 64M SDRAM).
u-boot printed fllowing information when I pushed the reset button.

...

All information seems good, but I can't input key to stop autoboot.
It seems  that it dont't accept any input from console.
I don't know why this happened.
Can anyone explain it?

Disable hardware flow control in your terminal emulation.

Please read the manual. See
http://www.denx.de/twiki/bin/view/DULG/SystemSetup#Section_4.3.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
It is not best to swap horses while crossing the river.
- Abraham Lincoln

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/