Re: Serial console failure on DENX Linux on MPC850 board

In message [ref] you wrote:

I am porting latest version  Denx linux
linuxppc_2_4_devel kernel and U-boot 3.0 to our MPC850
 board. I also used SELF to generate the ext2 file
system. I am using the TQM850L configuration

If your board is not a TQM850L you should be extremely carefult - you
will most probably need your own set of config options instead.

 on my board, and configured the SCC2 as serial
console(because the hardware designed like this).

And your hardware design is most probably different from that of  the
TQM850L< so be careful again.

I am stuck here and any response will be cordially
appreciated!

I guess your serial ports are misconfigured.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
"Here's a fish hangs in the net like a poor man's right in  the  law.
'Twill hardly come out."     - Shakespeare, Pericles, Act II, Scene 1

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/