Re: linuxppc_2_4_mpc5200 / 5200lite zImage now working

In message [ref] you wrote:

quoted

Thanks for sharing your experiences with the MPC5200Lite card.
Would it be possible for you to explain the steps you took to replace
dbug with u-boot. Did you use dbug or a bdm?
I am about to do the same thing, and fear that I might end up with a
"dead" card if
things go wrong : )

I actually did not eplace it all. I just compiled and programmed u-boot
to flash in diferent
address than 0xfff00000 I used 0xff800000 but it is not a good choice

This is not an optimal way to solve this.

I just checked in patches  for  U-Boot  to  allow  for  a  "low-boot"
configuration,  i.  e.  you  can configure and built U-Boot using the
commands "make MPC5200LITE_LOWBOOT_config;make all" and then  program
it at the low end of the flash (0xFF000000). After switching the boot
high/low  jumper  ("B  H/L") the board will boot directly into U-Boot
and all you need to switch back to dBUG is to switch the jumper back.

It may take a while until the new version of U-Boot shows up  on  the
CVS  server; the patch against U-Boot version 1.0.0 is also available
at ftp://ftp.denx.de/pub/u-boot/lowboot-1.0.0.patch.gz


Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
: ... and it's got weird formatting - Notepad, Write, Works  3  can't
: decipher it, and it's too big to go in DOS Edit. Help!
Install an operating system. :-)                  -- Tom Christiansen

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/