Re: Problem Programming Flash using BDI2000 on MPC8260ADS board

Dear Joao,

in message [ref] you wrote:

### Problem #1
Again after erasing the whole flash, the prog command (see below) shows
progress and returns a valid response

This doesn't sound like a problem to me :-)

BDI>prog 0xff800000 u-boot.srec SREC
Programming u-boot.srec , please wait ....
Programming flash passed

however, when reading back the flash the contents of the flash still
display all FF's

Note that the "prog" command does not list a  load  address,  but  an
OFFSET.  The  u-boot.srec file already contains a load address, which
matches the TEXT_BASE defined in your board/*/config.mk file - if you
add a offset of  0xff800000  you  are  programming  the  image  to  a
different location than you expect.

Also, I don;t think that 0xff800000 is where you  want  to  burn  the
image  to.  For the MPC8260ADS board, TEXT_BASE is set to 0xFFF00000,
so this is what you should try.

Finally, it makes little sense to waste your  time  with  a  S-Record
file - programming a binary image will be much faster.

So try:

	prog 0xFFF00000 u-boot.bin BIN

[untested, as I don't have such a board]


Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
I'm a programmer: I don't buy software, I write it.
                                                  -- Tom Christiansen

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/