Re: parallel I/O ports & opend darin pins on MPC8xx

 I hope it is not a Hardware problem. Do you
need an external pullup? If you do not have one,
then the problem arises (had the same problem once).
Except if one of your peripherals actively drives
your input....

                       Cheers
                            Dimitris.

--- Stephan Linke <Stephan.Linke@epygi.de> wrote:

Hi,

on one of our boards we are using one of the I/O
pins in open drain mode. This leads to some problems
in combination with other
drivers that write to the ports data register. Since
they can not detect the current output value of the
open drain pin. They only
see the status of the I/O pin no matter who forces
the value the CPM or another device connected to the
open drain pin. After
writing back the value read from the I/O data
register this value is forced by CPM which is
normaly wrong.

Did anyone run into that problem in the past? What
was your solution? Any thing else but NOT using open
drain pins?

Thanks, Stephan

=====
------------------------------------------------------------
-Dhmhtrios Meidanis
-Degree in Mathematics, University of the Aegean.
-Master in Computer Architecture and Digital
 Systems, University of Crete.
 Greece.
------------------------------------------------------------


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/