RE: EP405 network interface

You need to look at the board's user manual.  There is a section called
"Board Control and Status Registers"

-----Original Message-----
From: Toni Van Remortel [mailto:t.vanremortel@ha.be]
Sent: Wednesday, July 02, 2003 10:25 AM
To: Steven Blakeslee
Cc: PPC Mailinglist
Subject: RE: EP405 network interface


How and where?

I found that the PHY address in the manual is 0b00000 and in the code
PPC405_PCI_PHY_MEM_BASE is set to 0x80000000.


Op do 26-06-2003, om 20:39 schreef Steven Blakeslee:

Did you enable the phy in the Board Control Status Register?

-----Original Message-----
From: Toni Van Remortel [mailto:t.vanremortel@ha.be]
Sent: Thursday, June 26, 2003 10:01 AM
To: PPC Mailinglist
Subject: EP405 network interface



Hi all,

I cannot get the NIC working on my EP405. I used the ep405_config from
the linuxppc_2_4_devel tree.

This is a part of the output:

...
loop: loaded (max 8 devices)
eth0: No PHY device found.
removing net dev
...

So it seems that the kernel doesn't find the NIC (but it is there, and
working, ep-bootloader can use it to download the image).

Anybody an idea?

I already checked the NIC support, and the onboard-IBM NIC support is
enabled.

Regards,
--
                           Toni Van Remortel
              Wetenschappelijk Medewerker - D-science lab
                 Tel: 03 205 61 72 - Fax: 03 205 61 95
                      E-mail: t.vanremortel@ha.be

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/