Re: Re[2]: initrd for MPC860/862 with eldk2.1.10

In message [off-list ref] you wrote:

Thanks for your help.
I still can't go on.
This is my problem in details. Am I doing something wrong?
My board is EP PPC862 64M Ram 64M Flash.

I made following:
cp /usr/local/eldk/ppc_8xx/images/ramdisk_image.gz arch/ppc/boot/images/ramdisk.image.gz

make menuconfig , Eanbled ramdisk 4M
 <*> RAM disk support
(4096)   Default RAM disk size
   [*]   Initial RAM disk (initrd) support

make zImage.initrd

So far, this looks good to me.

zsrec arch/ppc/boot/images/zImage.initrd.embedded > /tftpboot/zImage.xxx1 ### This will create S-Record image

After it on PPC it looks like

quoted

t

Load using tftp via Ethernet
Enter server IP address <10.4.8.25> :

I cannot help with this part, though. We don't use the EP bootloader.
We use U-Boot on our boards, where things are different (simpler).

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
If the car industry behaved like the computer industry over the  last
30  years, a Rolls-Royce would cost $5, get 300 miles per gallon, and
blow up once a year killing all passengers inside.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/