Re: Problem porting ppcboot on custom board

In message [ref] you wrote:

Problem:
Serial port is not printing any character on the hyperterminal. I used
CRO to see any activity on the transmit pin (TXD pin) but there is
nothing happening.

This is off-topic on a LInux mailing list.

Also, you should not use PPCBoot for any new work.  PPCBoot  develop-
ment has been discontinued. Use U-Boot instead.

Your chances for  useful  replies  are  better  on  the  u-boot-users
mailing list.

Iam using BDI2000 emulator just to load the ppcboot code and see the
dump.

Can u please suggest possible place where something might have gone
wrong?

Use GDB and the BDI2000 to actually debug your code. You got a  great
tool, use it's capabilities.


Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
"It's when they say 2 + 2 = 5 that I begin to argue."    - Eric Pepke

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/